A swimming pool pump is considered the most important piece of equipment used for the proper maintenance and upkeep of swimming pools. If you are willing to spend a significant amount of money on the construction or installation of a pool, then it would be a good idea to make sure you have the necessary equipment to keep your pool in great working condition.
The swimming pool pump is a mechanical device that works with the filter to maintain the cleanliness of the pool. Today, there are pool pumps that come in all sizes and pumping capabilities. Some are designed to work with smaller above ground pools, and some are designed to work with “in-ground” pools. Whatever type of pool you have, you should be able to find a pool pump that will keep your pool clean and safe.
Although pool pumps are relatively easy to install and use, there are times when you need to troubleshoot. Here are some pool pump instructions for the most common problems you may encounter with your pool pump.
Pool Pump Keeps Running Without Moving The Water
There are actually a number of reasons why the pump is not moving water. There could be an air pocket in the pump, which prevents the water from passing through. When this happens, you would need to open the pump and manually pour water in. Another reason is that the filter is clogged. When this happens, you need to clean the filter. The pump’s impeller blade could also be broken, making the motor run, but unable to actually move the water. If this happens, then the transparent canister where the water flows through must be observed. If there is water, but it is not moving, then it means that the impeller is broken, and you may need to replace the entire pump. Another reason could be that the input or output pipes are blocked by debris. You could assume this is the problem if all the other possibilities have been checked. If this is the case, then you would need to have either a plumber or a pool repairman run a flexible tubing through the pump’s pipes to clear the blockage.
Pump Is Noisier Than Normal
Most pool owners get to practice their troubleshooting pool pumps skills when their pump becomes a bit too noisy. The pump essentially has a cooling fan that is designed to cool the electrical structure of the pump. This fan normally makes some amount of noise as it runs. However, there may be other reasons why the pump is noisier than usual. If the pump was vibrating against some kind of concrete base, then it would definitely make a louder noise. What you could do is slide a rubber matting underneath the pool pump to silence it a bit. Another reason is that the motor’s bearings could already be worn out. This normally happens if you have been using the pump for several years. This could be worsened if you have fed the skimmer more than the necessary amount of chemical tablets, as doing so could eat away at the bearings which could eventually cause premature wear. When this happens, then the bearings have to be replaced by a certified pool repairman.
Pump Keeps Turning On And Off
This could also happen for a number of reasons. First, the pump might have been wired to the wrong voltage. Pool pumps could be wired either to 115 volts or to 220 volts, depending on which voltage is commonly used in the country where it has been installed. If this happens, then an electrician would have to verify and correct the issue. The pump could also be overheating because the internal fan is broken. You can check this by pressing your hand on the side of the pool pump. If it is painfully hot, then the pump needs to be disconnected and taken to a pool repair shop so the problem can be properly verified and fixed.
These are just a couple of the common problems that you may have with your pool pump. Troubleshooting pool pumps can be easy as long as you know what to do. If you encounter any other problems, you could research online for some more troubleshooting pool pumps tips or pool pump instructions to help you out.